Step 1: Turn on the HerbalAire
First decide whether you are using direct inhalation or going to go with balloons. For either you first want to turn the vape on and turn the heating dial to the recommended temperature of 365 degrees. The vape should heat up after about three minutes.
Step 2: Heat up the HerbalAire
You are going to know the vape is heated up when a green LED light glows, illuminating under the base of the vape.
Step 3: Pack the HerbalAire
Next you load your herb into the filling chamber. Now for direct inhalation you will insert the Teflon main mouth piece into the top of the vape, for balloons you will stick the balloon at the top of the vape. But for balloons you have to connect the separate forced air part to the back and plug it in.
Step 4: Attach the HerbalAire whip or balloon
For direct inhalation you simply pull after you connect the whip. For the balloons you want to start the forced air after plugging it in and attach the balloons to the top. The pieces should fit perfectly together when connected.
Step 5: Refill the HerbalAire
When finished you turn the temperature dial all the way down and the unit will begin to cool. After letting it sit for about twenty minutes you can unplug it and pack it away for future use.
Tip: Always wait for the base of the HerbalAire to start glowing, so you know it is fully heated up. Starting vaporizing any sooner will just result in a sub-par vaporizing experience and you won’t be getting the full potential of the vaporizer.
If you haven’t read the review of the HerbalAire H2.1 I can’t think of one good reason why? You can find it here. Want to get this vaporizer? Be smart and compare prices and vendors for the HerbalAire before you decide!